CNC 500 Selectra

by advanced print solutions in CNC. Posted December 11, 2019

The CNC 500 Selectra is a triple axes control (X-Y-R) and it has been designed for press brakes and shears. It is simple to install, easy to use and doesn’t require any specialist operator training. This numeric control is a cost effective solution to your everyday fabrication problems.The system, easy to use, is programmed via a front panel keyboard. In just a few short steps a program is complete. A library of standard tooling, the bend allowance and the automatic calculation of the angle minimize the programming time. Thanks to the characteristic of the immediate calculation the program is ready in just a few short steps. Alternatively, you can run the program manually, set the actual position, check processing and make the necessary corrections.

TECHNICAL FEATURES

Compact single module design
99 programs of 9 steps each, automatic chaining
Sensitity 0.01 mm (0.001 inch)
Maximum velocity 20 m/min. (with 10 mm screw)
Maximum travel 1 m (5 digits)
Immediate conversion between mm and inch also in motion
Library of standard tooling (24 tools)
Immediate angle programming
N. 2 transistor drivers to control 3 DC motors (optional)
Programmable retract distance and time delay
4 programmable auxiliary outputs
Automatic parameters retention
Programmable parts counter
Auto-teach mode for saving positions
Automatic step cycling for test and calibration

CNC 500 Selectra

Leave a Reply Cancel reply

ABOUT AGENCY

CONTACTS